Pesce, C.; Blasco-Gimenez, Ramon; Riedemann, J.; Andrade, I.; Peña, R.(Institute of Electrical and Electronics Engineers (IEEE), 2016-09)
[EN] This paper proposes a DC-DC power converter topology based on a modified Flyback Converter (FC). The aim of the proposed topology is to increase the voltage gain by connecting the inputs of N isolated FCs in parallel ...
[EN] A multilevel modular DC DC power conversion topology based on cascaded H-Bridge converters in a double II configuration is presented. The topology is intended to interconnect large power DC networks. A two level control ...
In this paper a probabilistic economic dispatch model considering thermal units (fuel generators), photovoltaic
arrays and wind energy conversion systems is proposed. Wind speed, solar radiation and power
demand are ...
[EN] This paper presents an aggregation technique based on the resolution of a multi-objective optimization problem applied to the admittance model of a wind power plant (WPP). The purpose of the presented aggregation ...
[EN] The development of distributed generation, mainly based on renewable energies, requires the design of control strategies to allow the regulation of electrical variables, such as power, voltage (V), and frequency (f), ...
[EN] Countries with a limited interconnection capacity suffer substantial frequency variations after large incidents so they use automatic under-frequency load shedding schemes to arrest the frequency decay. Some of these ...
[EN] The aim of this work was to study linear deterministic models to predict tissue temperature during radiofrequency cardiac ablation (RFCA) by measuring magnitudes such as electrode temperature, power and impedance ...
Navarro Martínez, Gala(Universitat Politècnica de València, 2021-07-26)
[ES] Diseño de sistemas de control de los convertidores del lado de red de aerogeneradores para que tengan la funcionalidad de "creación de red", que permite la conexión de múltiples aerogeneradores en isla y la conexión ...
Martínez Gainza, Aurora(Universitat Politècnica de València, 2016-09-23)
[ES] Este trabajo de fin de grado tiene como objetivo principal realizar el estudio del comportamiento de
diferentes anclajes de turbinas flotantes. Para ello, se ha estudiado en primer lugar el comportamiento
de una ...
Ciudad-Real Villaescusa, Alejandro(Universitat Politècnica de València, 2024-11-26)
[ES] El objetivo de este Trabajo de Fin de Máster (TFM) es el modelado y control de un generador de Tipo III con capacidad de formación de red. El sistema del aerogenerador se compone de varios subsistemas, siendo los ...
Navarro Martínez, Gala(Universitat Politècnica de València, 2023-11-16)
[ES] El objeto de este TFM es el modelado y control de un aerogenerador offshore ¿grid-forming¿ de 15MW direct-drive. Este aerogenerador se divide en tres subsistemas: mecánico-aeroelástico, convertidor del generador y ...
Maneus Salvador, Eva(Universitat Politècnica de València, 2018-09-11)
[EN] In the future, aviation will most certainly tend to be electric, reason why there exists an
increasing interest in developing electrically propelled aircrafts. An option is to replace
traditional fuel engines with ...
Blasco-Gimenez, Ramon; Añó Villalba, Salvador Conrado; Peña, R.S.(Institute of Electrical and Electronics Engineers (IEEE), 2013-11-13)
[EN] This paper includes the study of a control strategy for the connection of PMSG-based wind turbines during unbalanced faults in weak grids. The wind turbine front-end converter is controlled in the stationary frame by ...
Rodríguez D'Derlée, Johel José(Universitat Politècnica de València, 2013-12-16)
The selection of the bulk power transmission technology in offshore wind
farms is strongly related to the wind farm size and its distance to shore.
Several alternatives can be evaluated depending on the rated power of ...
Arocas Pérez, José(Universitat Politècnica de València, 2015-05-28)
En el presente trabajo se desarrolla una plataforma de desarrollo de algoritmos de control para investigación y desarrollo de parques eólicos offshore, bajo los paradigmas de Rapid Control Prototyping o generación automática ...
Purpose: To assess whether tailoring the Kp and Ki values of a proportional-integral (PI) controller during radiofrequency (RF) cardiac ablation could be advantageous from the point of view of the dynamic behaviour of the ...
Reyes, Eduardo; Sarasiri, Nuapett; Pena, Ruben; Riedemann, Javier; Andrade, Iván; Blasco-Giménez, Ramón; Jara, Werner(Institute of Electrical and Electronics Engineers, 2022-10)
[EN] This letter presents a Space Vector Pulse Width Modulation (SVPWM) strategy for reducing the DC-link current harmonics in a multi- Voltage Source Inverter (VSI) topology with common DC-link bus. The DC current harmonic ...
Colmenero, Manuel; Blanquez, Francisco Rafael; Blasco-Gimenez, Ramon(Institute of Electrical and Electronics Engineers, 2023-11-29)
[EN] The future circular collider (FCC) is a cutting-edge particle accelerator being planned by the European Organization for Nuclear Research (CERN). It is designed to delve deeper into the mysteries of the universe than ...
García Cavero, Javier(Universitat Politècnica de València, 2018-04-13)
[ES] Este trabajo está enfocado al control avanzado de microrredes que funcionan con corriente
continua. Para realizar dicho control, se han realizado tanto el modelado de una red formada por
inversores como el diseño ...