Iranzo Pedrón, Álvaro(Universitat Politècnica de València, 2020-12-09)
[ES] En el Trabajo que se muestra a continuación, se lleva a cabo el diseño mecánico de un recipiente
para almacenamiento de gas natural comprimido (GNC) en fase gas, a una presión normal de servicio de 𝑃n = 57 𝑏ar y ...
Cárcel González, Bernabé(Universitat Politècnica de València, 2016-03-01)
[EN] This PhD Thesis is aimed at widening and improving the existing knowledge on the relationships between structure and uni-axial compression mechanical properties of aluminium foams obtained by the melting route. ...
[EN] Graphene cryogels synthesis is reported by amine modification of carboxylated graphene oxide via aqueous carbodiimide chemistry. The effect of the amine type on the formation of the cryogels and their properties is ...
Romero-Sedo, Antonio-Manuel; Arrue-Burillo, Paloma; Cárcel González, Alfonso Cristóbal(Sociedad Española de Materiales, 2010-12)
En multitud de problemas hidráulicos de transporte de agua potable el proyectista se centra principal mente en los cálculos hidráulicos y mecánicos, dejando en un segundo plano la elección más adecuada de los materiales. ...
Carbonell Boix, Diógenes José(Universitat Politècnica de València, 2016-12-22)
[EN]
The alloy AA2024-T3 highly used on aerospace industry presents a heterogeneous structure and the new restrictions due to environmental hazards of the Chromate Conversion Coatings (CCC's), shows the need of a new ...
Alamar Tarazona, Carlos(Universitat Politècnica de València, 2021-01-27)
[ES] El TFG, asistido por la profesora Lidija Slemenik Per e, actual encargada del departamento de Ciencia de Materiales de la facultad de Mechanical Engineering de la Universidad de Eslovenia, trata sobre el estudio de ...
[EN] This article presents novel poly(amidoamine) (PAMAM) dendrimer-modified with partially-reduced graphene oxide (rGO) aerogels, obtained using the combined solvothermal synthesis-freeze-casting approach. The properties ...
Pérez Puig, Miguel Angel(Universitat Politècnica de València, 2014-01-07)
Las chapas de acero recubiertas con cinc o aleaciones Zn-Fe y Zn-Ni se emplean en la construcción de
carrocerías de automóvil para mejorar la resistencia a la corrosión. Entre los diferentes recubrimientos, las
aleaciones ...
In order to improve Ti6Al4V high-temperature resistance and its tribological properties, the deposition of TiAl intermetallic (Ti-48Al-2Cr-2Nb) coating on a Ti6Al4V substrate by coaxial laser cladding has been investigated. ...
Blasco Puchades, José Ramón(Universitat Politècnica de València, 2012-12-03)
[ES] Este trabajo tiene como objetivo analizar y optimizar un proceso de fusión selectiva por láser (SLM) de piezas para implantes médicos
a partir de polvos de aleación Co-Cr-Mo ASTM F75. El programa experimental se ...
[EN] Ultra-light eco-friendly graphene oxide (GO)-based aerogels are reported by simple one-step solvothermal self-assembly. The effect of varying parameters such as C/O ratio of GO; reducing agent amount; temperature; and ...
[EN] Low-density three-dimensional (3D) N-doped graphene aerogels by a one-step solvothermal method in the presence of ethylenediamine (EDA) are reported. The gelation, formation, and properties of the aerogels were studied ...