Resumen:
|
[ES] En siguiente Trabajo Final de Grado (TFG), se va a desarrollar un producto para poder ensanchar el tren delantero de un quad. Este constará de un kit compuesto por ocho láminas. Además, se realizará un estudio ...[+]
[ES] En siguiente Trabajo Final de Grado (TFG), se va a desarrollar un producto para poder ensanchar el tren delantero de un quad. Este constará de un kit compuesto por ocho láminas. Además, se realizará un estudio de desarrollo del producto tanto la de parte técnica como de la económica.
Se empezará examinando todos los productos existentes en el mercado a los que se les quiere hacer frente, incluyendo el estudio de los materiales con los que se pretende desarrollar.
Debido a la complejidad del análisis de las fuerzas, se creará todo el conjunto del tren delantero para poder así obtener unos resultados más fiables y reales del comportamiento del mismo.
Seguidamente con el software para desarrollo del CAD se llevará a cabo un estudio de las cargas aplicadas, ejecutando una simulación y analizando a través de una comparación las distintas opciones para poder seguir con el desarrollo de la forma más óptima.
Por último se elaborará el análisis económico del modelo, para comprobar si es posible diseñar el producto estudiado.
[-]
[EN] The final project, is going to develop a product to widen the front train of a quad. This will consist of a kit composed of eight sheets. In addition, a product development study will be carried ...[+]
[EN] The final project, is going to develop a product to widen the front train of a quad. This will consist of a kit composed of eight sheets. In addition, a product development study will be carried out on both the technical and economic aspects.
It will begin by analyzing all the existing products in the market to which they are addressing, including the study of materials with which it is intended to develop.
Due to the complexity of the analysis of the forces, the whole set of the front train is designed to be able to obtain a more reliable and real results of the same one.
Then using the software for development of the CAD, a study of the applied loads is carried out by performing a simulation and analyzing by comparison the different options to be able to continue with the optimal development of product.
Finally, the economic analysis of the model is performed to see if it is possible to produce it.
[-]
|