Bruscas Bellido, Gracia-MariaRomero Subiron, FernandoRosado Castellano, PedroSerrano, J.2016-03-022016-03-0220131877-7058https://riunet.upv.es/handle/10251/61369ntegrated development of machining and inspection plans is essential in dynamic manufacturing environments, especially when right first time manufacturing is required. In this work, a methodology, based on a new and extended use of tolerance charting, that allows incorporation of in-process inspection operations to improve process plans is presented. The methodology proposes the transfer of the manufacturing specification toleranc e between surfaces to specific ation tolerances established between these surfaces and a common reference system. In this way, all variability sources originated by part locating and fixturing can be separately considered from the ones originated by the process-machine system. This circumstance allows a more accurate calculation of operation capability indexes and eases the analysis and improvement of critical operations. To prove methodology potential, an application case is showed.Reconocimiento - No comercial - Sin obra derivada (by-nc-nd)Integrated process planningIn-process inspectionTolerance chartingINGENIERIA DE LOS PROCESOS DE FABRICACIONArtículo10.1016/j.proeng.2013.08.175Abierto