Calatayud Martí, Pilar(Universitat Politècnica de València, 2019-09-09)
[ES] El presente estudio tiene como objetivo la optimización energética en el proceso de producción de agua caliente en la empresa valenciana Mercavalencia S.A., logrando con ello una reducción de consumos y costes. Se ...
Alarcón Gallén, David(Universitat Politècnica de València, 2022-11-03)
[ES] El fenómeno de la aparición, el crecimiento y la acumulación de la escarcha penaliza el
funcionamiento eficiente de una bomba de calor aerotérmica entorpeciendo la transferencia de
calor entre el aire y el refrigerante, ...
Guimarey Docampo, Nerea(Universitat Politècnica de València, 2021-02-05)
[ES] El trabajo consiste en un estudio sobre las posibles opciones de suministrar calefacción y refrigeración simultáneamente para el campus universitario de Lyngby de la DTU (Danmarks Tekniske Universitet).
El objetivo ...
Ros Rausell, Ernesto(Universitat Politècnica de València, 2022-04-28)
[EN] The heat loss in nearly zero-energy buildings may be reduced to such a low level that is
similar to the internal heat gain shallow. Therefore, the internal heat gain significantly influences
the heating demand of ...
Mari Moreno, Salvador(Universitat Politècnica de València, 2019-09-19)
[ES] La producción de agua caliente sanitaria es una necesidad básica en nuestra sociedad a día de hoy. A menudo, este requerimiento de agua caliente es subsanado mediante la utilización de calderas tradicionales, tal y ...
Navarro Peris, Emilio(Universitat Politècnica de València, 2020-01-29)
[EN] This thesis is included within the objectives of the project of the Ministerio de Ciencia yTecnologia DICORE.Within the frame of this project, the thesis is focused in the study of hermetic piston compressors for ...
Espín López, Juan Miguel(Universitat Politècnica de València, 2020-05-06)
[ES] Los refugios de montaña son sistemas aislados que requieren especial atención a la hora de analizar el suministro de energía. Cada refugio de montaña presenta un determinado impacto ambiental debido a su operación a ...
Pallas Vázquez, Borja Tomás(Universitat Politècnica de València, 2022-07-26)
[ES] En el presente documento se compararán en términos energéticos, económicos y de impacto ambiental dos estrategias de renovación de un edificio residencial de vivienda colectiva existente, respecto a un caso base ...
Pitarch, Miguel; Navarro-Peris, Emilio; Gonzálvez-Maciá, José; Corberán, José M.(Elsevier, 2017)
[EN] Heat pumps that work with a high degree of subcooling in subcritical systems have shown a significant margin
of improvement when working with sanitary hot water applications. Recently, two different approaches ...
[EN] The performance of a transcritical cycle is highly dependent on the rejection pressure. The optimal rejection pressure depends mainly on the inlet and outlet temperatures at the heat sink (secondary fluid). For the ...
Masip, X.; Prades-Gil, Carlos; Navarro-Peris, Emilio; Corberán, José M.(Elsevier, 2021-11)
[EN] The current technologies used for DHW production in the city of Valencia (Spain) are mainly gas boiler
and immersion electric heater that are individual installations, high energy consuming technologies and
high CO2 ...
Navarro Peris, Emilio; Corberán Salvador, José Miguel; Ancik, Zdenek(Elsevier, 2015-10)
The present study evaluates the possibilities of increasing efficiency in refrigeration and heat pump systems based on compression cycles by means of using compressor heat losses. In order to do this, the work been divided ...
Pitarch, Miguel; Hervás-Blasco, Estefanía; Navarro-Peris, Emilio; Corberán, José M.(Elsevier, 2019-03)
[EN] The optimum performance of a pure subcritical refrigeration cycle depends significantly on the temperature lift of the heat source and sink. Therefore, the maximization of the system efficiency has to be linked to ...
Álvarez Piñeiro, Lucas(Universitat Politècnica de València, 2019-10-15)
[ES] Los intercambiadores de calor de placas soldadas se usan ampliamente en muchas aplicaciones industriales debido a su alta eficiencia, compacidad y rentabilidad. Para aplicaciones de recuperación de calor en bombas de ...
Álvarez-Piñeiro, Lucas; Albaladejo, Paloma; Navarro-Peris, Emilio; Schnabel, Lena; Corberán, José M.(Universidad de Castilla-La Mancha
José Antonio Almendros Ibáñez, 2019-06-14)
[EN] Braze plate heat exchanger (BPHE) are used widely in heating and cooling systems and the efficiency
of heat pumps depends critically on the proper performance of them. One of the most common factors
affecting the ...
Lopo, Miguel; Montagud, Arnau; Navarro-Peris, Emilio; Cunha, Isabel; Zille, Andrea; Fernández de Córdoba Castellá, Pedro José; Moradas-Ferreira, Pedro; Tamagnini, Paula; Urchueguía Schölzel, Javier Fermín(Karger Publishers, 2012-07)
[EN] Background/Aims: The influence of different parameters
such as temperature, irradiance, nitrate concentration, pH,
and an external carbon source on Synechocystis PCC 6803
growth was evaluated. Methods: 4.5-ml ...
[EN] The use of heat pumps in order to produce sanitary hot water have been demonstrated as a very efficient alternative to traditional boilers. Nevertheless, the high water temperature lift (usually from 10 degrees C to ...
Pitarch, M.; Navarro-Peris, Emilio; Gonzálvez-Maciá, José; Corberán, José M.(Elsevier, 2017)
[EN] This paper presents the experimental results obtained from a new heat pump prototype for sanitary hot water production, in the application of heat recovery from water sources like sewage water or condensation loops ...
Masip, X.; Álvarez-Piñeiro, Lucas; Hervas-Blasco, Estefanía; Navarro-Peris, Emilio; Corberán, José M.(Universidad de Castilla-La Mancha
José Antonio Almendros Ibáñez, 2019-06-14)
[EN] The water heating consumption of the average European dwelling accounts at this moment for
14.5 %, according to the European Commission, whereas heating and cooling percentage account
for 64.7 %. The European Union, ...
Pitarch i Mocholí, Miquel(Universitat Politècnica de València, 2017-05-29)
Heat pumps have been identified as an efficient alternative to traditional boilers for the production of sanitary hot water (SHW). The high water temperature lift (usually from 10ºC to 60ºC) involved in this application ...