Peydró Rasero, Miguel Ángel(Editorial Universitat Politècnica de València, 2014-09-22)
El proceso de inyección es un proceso de conformado de materiales poliméricos
termoplásticos que representa una notable importancia económica y tecnológica y
cuyo estudio ha supuesto multitud de investigaciones ...
Parres, F.; Crespo Amorós, José Enrique; Nadal Gisbert, Antonio Vicente; Navarro Vidal, Raúl(Smithers Rapra Technology, 2012)
The importance of recovering waste materials generated by industrialised societies is mainly due to the environmental impact that they have, and one of the principal problems is the presence of end of life tyres. The use ...
Martínez Sanz, Antonio Vicente(Universitat Politècnica de València, 2016-03-21)
[EN] The injection process is a very important part of the manufacture of thermoplastics. They are used for the fabrication of a wide variety of products because they comply perfectly with the overall objectives of low ...
Pascual Prats, Jordi Vicent(Universitat Politècnica de València, 2017-03-31)
[EN] The TFG consists in organization of the production lines dedicated to the furniture sector. It is composed for four big cells, first "INPUT", the raw material enters to the workshop, second "MANUFACTURING" prepares ...
ARRIETA, Marina Patricia; Parres García, Francisco José; López Martínez, Juan; Navarro Vidal, Raúl; Ferrándiz Bou, Santiago(Federación de Asociaciones de Ingenieros Industriales de España (FAIIE), 2012)
[EN] Pyrolysis of bioplastics waste may offer
an alternative waste treatment option,
allowing the recovery of resources.
Bioplastics have taken special interest
in the industry. They could be an
alternative to ...
It is a common industrial practice to blend virgin polymer with the same polymer recycled from scrap plastic that, in general, has not undergone relevant degradation. In this article, the influence that incorporating ...
Peydro, M. A.; Parres, F.; Crespo Amorós, José Enrique; Navarro Vidal, Raúl(Elsevier, 2013-08)
Recovery of recycled acrylonitrile-butadiene-styrene (ABS) through mixing with styrene-ethylene/butylene-styrene (SEBS) has been studied in this paper. To simulate recycled ABS, virgin ABS was processed through 5 cycles, ...
Peydro, M. A.; Parres, F.; Crespo Amorós, José Enrique; Navarro Vidal, Raúl(Federación de Asociaciones de Ingenieros Industriales de España (FAIIE), 2012-09)
[EN] Recovery of recycled acrylonitrile butadiene styrene (ABS) through mixing with styrene-ethylene/butylene-styrene (SEBS) has been studied in this paper. To simulate recycled ABS, virgin ABS was processed through 5 ...
This work shows the study of rheological behavior of a material that recycled materials have been incorporated. The transformation process to be applied is the injection molding. The mix of materials used was of the same ...
Crespo Amorós, José Enrique; Parres, F.; Peydro, M. A.; Navarro Vidal, Raúl(Wiley-Blackwell, 2013-04)
The effect of reprocessing Polyamide 6 (PA6) has been studied in this article. To simulate recycled PA, we reprocessed virgin PA through five cycles. The PA 6 has undergone mechanical, thermal and rheological characterization ...
This work studies the recovery of two grades of acrylonitrile butadiene styrene (ABS) contaminated with low-density polyethylene (LDPE), by adding styrene ethylene/butadiene styrene (SEBS). To simulate contaminated ABS, ...