[EN] In this study, the open-hole quasi-static tensile and fatigue loading behavior of a multidirectional CFRP thick laminate, representative of laminates used in the aerospace industry, is studied. Non-destructive techniques ...
Font Jareño, Alba(Universitat Politècnica de València, 2017-04-26)
Characterizing the in-plane shear response of thermoplastic composite materials is receiving considerably attention in order to provide important design parameters for industrial manufacturers. In this report, the in-plane ...
[EN] Cancellous bone yield strain has been reported in the literature to be relatively constant and independent from microstructure and apparent density, while fracture strain shows higher scattering. The objective of this ...
Garzón-Roca, Julio; Sena-Cruz, Jose M.; Fernandes, Pedro; Xavier, José(Elsevier, 2015-11)
[EN] The near-surface mounted (NSM) strengthening technique is capable of effectively increase the bearing capacity of structural concrete elements. This technique which basically consists of placing FRP reinforcements ...
Ronda Ballester, Álvaro(Universitat Politècnica de València, 2021-06-07)
[ES] Para medir la tensión durante el ensayo de tracción de las muestras a veces se requieren imágenes que deben ser relacionadas con los datos de la máquina de tracción. Esto podría hacerse pulverizando un polvo punteado ...
Mata Falcon, Jaime; Yu, Karin L.; Pallarés Rubio, Luis; Miguel Sosa, Pedro(Elsevier, 2025-01-01)
[EN] Reinforced concrete dapped ends are a widely used connection for precast elements in infrastructure and building structures. However, they are prone to major durability problems due to the formation of an inclined ...
Galkovski, Tena; Mata Falcon, Jaime; Kaufmann, Walter(Elsevier, 2023-10-01)
[EN] The interaction of reinforcing steel and concrete is decisive for the structural behaviour of reinforced concrete (RC) in the serviceability and ultimate limit state. In the past decade, distributed fibre optical ...
Gehri, Nicola; Mata Falcon, Jaime; Kaufmann, Walter(Elsevier, 2023-11-15)
[EN] Although fibre-reinforced concrete has been the subject of extensive research for decades, its mechanical behaviour in shear is still not well understood. Furthermore, hardly any large-scale shear tests on elements ...
[EN] Open cell polyurethane foams are often used as cancellous bone surrogates because of their similarities in morphology and mechanical response. In this work, open cell polyurethane foams of three different densities ...
Monserrat López, Andrea; Miguel Sosa, Pedro(Fédération Internationale du Béton (fib) - International Federation for Structural Concrete, 2021-06-16)
[EN] An extensive experimental programme consisting of 15 shear tests on continuous reinforced concrete beams was carried out to assess the shear strength of beams with and without shear reinforcement. The influence of ...
[EN] (1) Background: Open-cell polyurethane foam mechanical behavior is highly influenced by microstructure. The determination of the failure mechanisms and the characterization of the deformation modes involved at the ...
López, Andrea Montserrat; Miguel Sosa, Pedro Francisco(Elsevier, 2024-02-22)
[EN] Statically indeterminate structures such as continuous beams allow redistribution of internal forces. For increasing loads after yielding of the flexural reinforcement, shear forces and flexural deformations may ...
Monserrat López, Andrea; Fernánez Ruiz, Miguel; Miguel Sosa, Pedro(Elsevier, 2021-05-01)
[EN] The assessment of the shear strength of reinforced concrete beams with and without shear reinforcement is investigated in this paper on the basis of the contribution of the various potential shear-transfer actions. ...
[EN] Thin-walled textile-reinforced concrete beams have recently emerged as a promising approach for material-efficient design. However, the increased complexity of the formwork is a major challenge in implementing such ...