Cos-Gayón López, Fernando José; Lluesma, C.A.; Cordón Llácer, Joan; Anquela Julián, Ana Belén; Martín Furones, Ángel Esteban; Giner-García, María-Isabel(Perm National Research Polytechnic University, 2019-08-08)
[EN] The basis of this project is to implement the use of laser scanner to analyze structural
deformation in construction and its subsequent modeling to complete the 3D model of a building.
The advantages of a measurement ...
Morellá Campos, Álvaro(Universitat Politècnica de València, 2023-09-29)
[ES] Este documento recopila el procedimiento para la realización del Trabajo de Final del Grado en Ingeniería Electrónica Industrial y Automática, que se basa en el diseño de un sistema de Medición de la Salud Estructural ...
Bellod Tolsá, María(Universitat Politècnica de València, 2019-10-02)
[ES] El proyecto consiste en el diseño gráfico y estructural de un packaging de snacks.
El diseño se realiza para la empresa PepsiCo con la creación de una nueva marca de snacks saludables y un envase funcional y respetuoso ...
Pérez Gómez-Ferrer, Alberto(Universitat Politècnica de València, 2015-10-26)
[EN] This study will comprise a diagnosis of the current sewage network followed by the analysis of different solutions for the area. This area occupies a sector of the city bordered West by Aragón avenue, ...
Hueso Climent, Guillermo(Universitat Politècnica de València, 2015-09-21)
[EN] This study will comprise a diagnosis of the current sewage network followed by the analysis of different solutions for the area. This area occupies a sector of the city bordered West by Aragón avenue, South by Alameda ...
Reyes Martínez, Carlos(Universitat Politècnica de València, 2015-09-14)
[EN] This study will comprise a diagnosis of the current sewage network followed by the analysis of different solutions for the area. This area occupies a sector of the city bordered West by Aragón avenue, South by Alameda ...
Moscardó Castellets, Ignacio(Universitat Politècnica de València, 2015-09-11)
[EN] This study will comprise a diagnosis of the current sewage network followed by the analysis of different solutions for the area. This area occupies a sector of the city bordered West by Aragón avenue, South by Alameda ...
Sleiman Gutiérrez, Natalia(Universitat Politècnica de València, 2019-01-10)
[EN] The objective of this document is to increase the base width of an arch bridge in Gandía (Valencia). For this purpose, a structural evaluation is carried out first of all in order to check the good behavior and safety ...
Ahuir Pérez, Carla(Universitat Politècnica de València, 2019-01-10)
[EN] The objective of this document is to increase the base width of an arch bridge in Gandía (Valencia). For this purpose, a structural evaluation is carried out first of all in order to check the good behavior and safety ...
Jiménez Arenas, Carlos(Universitat Politècnica de València, 2015-01-19)
[ES] Este proyecto de diseño busca desarrollar un mueble modular para el hogar que se centre exclusivamente en el ámbito deportivo. El mueble será capaz de albergar en su interior el material deportivo del usuario en ...
Fernández Garijo, Óscar(Universitat Politècnica de València, 2020-05-22)
[ES] Este Trabajo de Fin de Grado está basado en la participación en un European Project Semester llevado a cabo en la Universidad de Ciencias Aplicadas de La Haya. Se trata de un proyecto que comenzó en 2017, con el ...
Diaz-Anichtchenko, Daniel; Aviles-Coronado, Jesus E.; López-Moreno, Sinhué; Turnbull, Robin; Manjón, Francisco-Javier; Popescu, Catalin; Errandonea, Daniel(American Chemical Society, 2024-03-30)
[EN] This paper reports an experimental high-pressure study of natural mineral ferberite (FeWO4) up to 20 GPa using diamond-anvil cells. First-principles calculations have been used to support and complement the results ...
Lorencio Penalva, Jorge(Universitat Politècnica de València, 2017-10-20)
[EN] The aim of the current document is the development of a geotechnical and geologic study about the implementation of a high-speed railway tunnel which goes under the city of Valladolid.
Due to the fact of the existence ...
Llácer Arana, Guillermo(Universitat Politècnica de València, 2017-10-25)
[EN] The aim of the current document is the development of a geotechnical and geologic study about the implementation of a high-speed railway tunnel which goes under the city of Valladolid.
Due to the fact of the existence ...
Catalán Pérez, Jorge(Universitat Politècnica de València, 2016-10-20)
[EN] This Project it's include in a "multidiscipline project" that covers students from different specialities with the purpose of elaborate a viable alternative from de development of the deviation of the CV-35 passing ...
Sánchez Caballero, Samuel; Sellés Cantó, Miguel Ángel; Peydró Rasero, Miguel Ángel; Juárez Varón, David(Editura Universitatii din Oradea, 2013)
Structural optimization requires a large numberof structures to be evaluated. In simultaneous size and shapeoptimization, where only metaheuristics techniques can beused, the number of evaluations can easily ran into ...
Monzón Sanjuan, Cristian(Universitat Politècnica de València, 2014-07-14)
[EN] The object of this project is the design using simplified models the structure of an industrial building formed by elements of concrete prefabricated, for the work of maintenance of vehicles and logistics services in ...
Sánchez Caballero, Samuel(Editorial Universitat Politècnica de València, 2012-05-04)
La optimización de estructuras ha sido una disciplina muy estudiada por numerosos investigadores durante los últimos cuarenta años. A pesar de que durante los primeros veinte años las técnicas de Programación Matemática ...
[EN] This joint experimental and theoretical study of the structural and vibrational properties of beta-In2S3 upon compression shows that this tetragonal defect spinel undergoes two reversible pressure-induced order¿disorder ...
Monkerud Garreta, Nicolás Kevin(Universitat Politècnica de València, 2018-11-21)
[ES] En la actualidad, la metodología empleada para realización de inspecciones de ensayos no destructivos (END) requiere una gran labor por parte del técnico: calibración del equipo, familiarización con la zona a inspeccionar, ...