Aqueous electrolyte contacts have been used to characterize CdS thin films grown using chemical bath deposition (CBD) on 4 different fluorine-doped tin oxide (FTO) coated conducting glass substrates (identified by the ...
Domingo Beltran, Manuel; Luna Molina, Ramón; Satorre, M. Á.; Santonja Moltó, Mª del Carmen; Millán Verdú, Carlos(MDPI, 2015-10)
The use of thin films is extensive in both science and industry. We have created
an experimental system that allows us to measure the thicknesses of thin films (with typical
thicknesses of around 1 μm) in real time ...
Doumbia, Youssouf(Universitat Politècnica de València, 2024-02-19)
[ES] El presente trabajo titulado "Elaboración y caracterización de láminas delgadas híbridas
orgánico-inorgánicas de perovskita para células solares fotovoltaicas" es una contribución a la
mejora del rendimiento y la ...
Abstract CuGaSe2 and CuGaS2 polycrystalline thin film absorbers were prepared by one-step electrodeposition from an
aqueous electrolyte containing CuCl2, GaCl3 and H2SeO3.
The pH of the solution was adjusted to 2.3 by ...
[EN] The viability of the electrodeposition as a suitable technique for preparing new porous hybrid materials has been tested in this paper. Hybrid ZnO films with two different organic dyes: Eosin-Y and Tetrasulphonated- ...
Moya, Mónica; Marí, B.; Mollar García, Miguel Alfonso(SciELO Comision Nacional de Investigacion Cientifica Y Tecnologica, 2019-04)
[EN] Thin films of Zinc Oxide (ZnO) were grown on glass substrates conductive FTO (Fluorine-doped tin oxide)
with a thickness of 400 nm. The hybrid films of ZnO and dye (N719) were grown on FTO conductive glass
to a thickness ...
In this work, CuInSe 2 based flexible photovoltaic cells have been fabricated completely using non-vacuum low-cost techniques. Thin films were deposited on molybdenum thin foil substrates by electrodeposition using a ...
[EN] Using the easily applicable hydrothermal method Cr-doped hematite thin films have been deposited polycrystalline on conductive glass substrates. The hydrothermal bath consisted of an aqueous solution containing a ...
Frindy, Sana; Primo Arnau, Ana María; Qaiss, Abou el Kacem; Bouhfid, Rachid; Lahcini, Mohamed; García Gómez, Hermenegildo; Bousmina, Mosto; El Kadib, Abdelkrim(Elsevier, 2016)
[EN] Three natural clay-based microstructures, namely layered montmorillonite (MMT), nanotubular halloysite (HNT) and micro-fibrillar sepiolite (SP) were used for the synthesis of hybrid chitosan-clay thin films and porous ...
[EN] Presently, we inquire about the organic/inorganic cation effect on different properties based on structure, morphology, and steadiness in preparing a one-step solution of APbI(3) thin films, where A = MA, FA, Cs, using ...
The inside cover shows two types of photonic structures selectively deposited with a highly fluorescent and transparent organic thin film, as reported by Angel Barranco and co-workers on p. 761. These structures select and ...
Valdés, M.; Mollar García, Miguel Alfonso; Vazquéz, M.; Marí Soucase, Bernabé(Springer Verlag (Germany), 2013-06)
[EN] CuInSe2 thin films were deposited on goldcoated alumina electrodes using constant and pulsed potential signals. In situ electrochemical measurements were recorded with an atomic force microscope to follow CuInSe2 ...
[EN] This paper reports onthe growth of quaternary Cu2ZnSnS4 (CZTS) thin films by a single step electrochemicaldeposition followed by annealing at low temperature.The influence of different annealing atmospheres at constant ...
Sall, Thierno; Marí, B.; Mollar García, Miguel Alfonso; Sans-Tresserras, Juan Ángel(Springer-Verlag, 2017)
[EN] The preparation and analysis of morphological, structural, optical, vibrational and compositional properties of tin monosulfide (SnS) thin films deposited on glass substrate by chemical spray pyrolysis is reported ...
[EN] In2S3 thin films have been elaborated onto glass substrate by SILAR method at room temperature using different immersion time in the solution of cation and anion and fixing the rinsing time. The film composition, ...
Urbaniak, A.; Pawlowski, M.; Marzantowicz, M.; Marí, B.; Sall, Thierno(Elsevier, 2018)
[EN] SnS is an earth-abundant material that is a potentially suitable candidate for the absorber layer in solar cells. Here spray-pyrolized SnS thin films doped with vanadium were studied using structural and opto-electrical ...
Casquel, R.; Soler, J. A.; Holgado, M.; Lopez, A.; Lavin, A.; de Vicente, J.; Sanza, F. J.; Laguna, M. F.; Holgado Bolaños, Miguel; Bañuls Polo, María-José; Puchades, Rosa(Optical Society of America, 2015-05-18)
In this work we present an optical technique for characterizing sub-micrometric areas based on reflectivity of the light as a function of angle of incidence for the two pure polarizations s and p, covering a range of angles ...
[EN] Perovskite materials for solar cell applications were prepared by a one-step method. In the following work, the spin coating technique was used for organic-inorganic hybrid perovskite formamidinium lead tribromide ...
Sall, Thierno; Mollar García, Miguel Alfonso; Marí, B.(Springer-Verlag, 2017)
[EN] SnS thin films were deposited by chemical spray pyrolysis using cost-effective and low-toxicity sources materials like tin (II) chloride dihydrate and thiourea as sources of tin and sulphur, respectively. We have ...