Characterization of the turbulent flame front surface in spark ignition engines during spark ignition operation to identify controlled auto-ignition and abnormal combustion

Abstract

[EN] The combustion diagnostics and subsequent analysis are standardized tools based on the estimation of the heat release law (HRL). From this estimation, the different combustion parameters can be obtained: combustion phasing and duration, heat release rate, and so on. This analysis might be usually enough to study traditional spark ignition (SI) engines. However, with the new upcoming SI engines, this is probably not the case anymore, since different combustion modes can be operated in the same engine, as for instance a combination of SI and controlled auto-ignition (CAI) combustion modes. When different combustion modes are combined, it seems interesting to study in more depth the HRL, trying to get more data and to study the differences among the diverse combustion modes. Toward this end, a methodology to go deeper in the study of the HRL is proposed in this work, consisting of, mainly quantifying and taking into account the most relevant influencing parameters: the fuel properties (mainly its lower heating value), the in-cylinder oxygen content, the density of the burned and unburned zones, the laminar combustion speed, and the turbulence effect. With the proposed methodology, a standard SI combustion, developed by a flame front, can be characterized at any given operating point. This would allow to predict which the combustion developement would be, at this operating point, assuming it to be developed by a flame front. Subsequently, this SI combustion prediction can be compared to the one obtained experimentally, making it possible to identify and analyze abnormal combustion phenomena, as well as to study the differences between a combustion developed by a flame front (SI) and by auto-ignition (CAI). Derived from this work, an alternative equation to experimentally characterize the laminar combustion velocity has also been proposed, in order to improve its applicability in a wider range of fuel/air ratios and dilution degrees.