Borrell Tomás, María Amparo; Salvador Moya, Mª Dolores(Editorial Universitat Politècnica de València, 2015-10-15)
El Carbono es un elemento fascinante, capaz de dar lugar a muy diversos e increíbles materiales. Se conocen cerca de 16 millones de compuestos de carbono y forma parte de todos los seres vivos conocidos. Si se organiza en ...
[EN] This study aims to evaluate the mechanical behavior of nanostructured and conventional alumina-titania coatings by means of combining four-point bend tests monitored with acoustic emission. Determination of bending ...
Presenda Barrera, Álvaro; Salvador Moya, Mª Dolores; Peñaranda Foix, Felipe Laureano; Catalá Civera, José Manuel; Borrell Tomás, María Amparo(Trans Tech Publications, 2014-10)
[EN] Ceramics for dental applications have become increasingly important in the last decades.
Particularly, the introduction of yttria-stabilized zirconia tetragonal polycrystalline (Y-TZP)
materials as an alternative ...
Benavente Martínez, Rut; Salvador Moya, Mª Dolores; Penaranda-Foix, Felipe L.; Pallone, Eliria; Borrell Tomás, María Amparo(Elsevier, 2014-08)
Microwave sintering has emerged in recent years as a novel method for sintering a variety of materials that have shown significant advantages
against conventional sintering procedures. This work involved an investigation ...
Double-layer and graded composite coatings of yttria-stabilized zirconia were sprayed on metallic substrates by atmospheric plasma spray. The coating architecture was built up by combining two different feedstocks: one ...
[EN] Medium strength AW7XXX aluminium alloys are widely used as welded structures and in transportation. The applications of these alloys are limited by the behaviour of the welded joints. There is no agreement on the joint ...
Bloem, Carlos; Salvador Moya, Mª Dolores; Amigó, Vicente; Busquets Mataix, David Jerónimo(Taylor & Francis, 2004)
[EN] Many researchers have undertaken studies into the mechanical behaviour of the welded bond,1,2 others have devoted their attentions to metallurgical phenomena, whether concerning phenomena inherent to the area immediately ...
Bonache Bezares, Victoria; Salvador Moya, Mª Dolores; García-Rocha, Victoria; Borrell Tomás, María Amparo(Elsevier, 2011-04)
The aim of this present work is to study the effect of VC and/or Cr 3C 2 in densification, microstructural control and mechanical behaviour of WC-12Co ultrafine and nanocrystalline mixtures, consolidated by spark plasma ...
[EN] There are also important complementary stabilization treatments of the microstructure by means of controlled cooling at high speeds it avoids the formation of beta phases in grain boundaries, at the same time that ...
[EN] A commercial nanosuspension of yttria-stabilised zirconia (YSZ) was successfully deposited on austenitic stainless steel substrate by suspension plasma spraying technique (SPS). A SG-100 torch with internal radial ...
Gil-Flores, Lorena; Salvador Moya, Mª Dolores; Penaranda-Foix, Felipe L.; Fernández, Adolfo; Suárez-Menéndez, Marta; Rosa, Roberto; Veronesi, Paolo; Leonelli, Cristina; Borrell Tomás, María Amparo(Elsevier, 2019-10-01)
[EN] Aim of the present study is to sinter zirconia nanocomposite powders doped with ceria and toughened with alumina (10Ce-TZP/Al2O3) by non-conventional means, i.e. microwave sintering technology. The sintering effects ...
Carpio, Pablo; Borrell Tomás, María Amparo; Salvador Moya, Mª Dolores; Gómez, Andres; Martínez, Eduardo; Sánchez, Enrique(Elsevier, 2015-04)
Atmospheric plasma spraying (APS) is an attractive technique to obtain nanostructured coatings due to its versatility, simplicity and relatively low cost. However, nanoparticles cannot be fed into the plasma using conventional ...
Bordes, M. C.; Vicent, M.; Moreno, A.; Moreno, R.; Borrell Tomás, María Amparo; Salvador Moya, Mª Dolores; Sanchez, E.(2013-04-15)
In recent years, intense research has shown that thermal spray techniques, especially atmospheric plasma spraying (APS), can be used to obtain nanostructured TiO2 coatings with effective photocatalytic activity. This study ...
In this study, TiO 2 coatings were deposited by suspension plasma spraying (SPS) from a commercial TiO 2 nanoparticle suspension on two different substrates: a standard stainless steel and a Pyrex glass. Coatings were ...
Borrell Tomás, María Amparo; Salvador Moya, Mª Dolores; Penaranda-Foix, Felipe L.; Catalá Civera, José Manuel(Wiley, 2012-02-09)
Commercially, 3mol% Y2O3-stabilized tetragonal zirconia (7090nm) compacts were fabricated using a conventional and a nonconventional sintering technique; microwave heating in a resonant mono-mode cavity at 2.45GHz, at ...
Moratal, Sheila; Benavente Martínez, Rut; Salvador Moya, Mª Dolores; Penaranda-Foix, Felipe L.; Moreno, Rodrigo; Borrell Tomás, María Amparo(Elsevier, 2022)
[EN] The objective of this work is to study the changes in the physical and mechanical properties of strontium-doped lanthanum manganite (LSM) material and LSM-YSZ (ZrO2 doped with 8 mol% yttria) composite, obtained by ...
Borrell Tomás, María Amparo; Salvador Moya, Mª Dolores; Miranda, Míriam; Peñaranda Foix, Felipe Laureano; Catalá Civera, José Manuel(Bentham Science Publishers, 2014)
[EN] Microwave sintering has emerged in recent years as a promising technology for faster, cheaper and eco-friendlier processing
of a wide variety of materials, which are regarded as significant advantages against ...
Benavente Martínez, Rut; Salvador Moya, Mª Dolores; Peñaranda Foix, Felipe Laureano; García-Moreno, Olga; Torrecillas, Ramón; Borrell Tomás, María Amparo(Scientific.Net, 2014)
[EN] Microwave sintering has emerged in recent years as a new, fast, cheap and green technology for sintering a variety of materials. The main advantages of microwave heating can be summarized as follow: reduced processing ...
Benavente Martínez, Rut; Salvador Moya, Mª Dolores; Borrell Tomás, María Amparo; García Moreno, Olga; Peñaranda Foix, Felipe Laureano; Catalá Civera, José Manuel(Wiley, 2015-06)
Lithium aluminosilicate was fabricated by conventional and non-conventional sintering: microwave and spark plasma sintering, from 1200 to 1300 ºC. A considerable difference in densification, microstructure, coefficient of ...
Fariñas, Juan Carlos; Moreno, Rodrigo; Pérez, A.; García, M. A.; García-Hernández, M.; Salvador Moya, Mª Dolores; Borrell Tomás, María Amparo(Elsevier, 2018)
[EN] A simple, soft, and fast microwave-assisted hydrothermal method was used for the preparation of nanocrystalline cobalt ferrite powders from commercially-available Fe(NO3)(3)center dot 9H(2)O, Co(NO3)(2)center dot ...