- -

Influence of custom-made and prefabricated insoles before and after an intense run

RiuNet: Repositorio Institucional de la Universidad Politécnica de Valencia

Compartir/Enviar a

Citas

Estadísticas

  • Estadisticas de Uso

Influence of custom-made and prefabricated insoles before and after an intense run

Mostrar el registro sencillo del ítem

Ficheros en el ítem

dc.contributor.author Lucas-Cuevas, Ángel es_ES
dc.contributor.author Camacho García, Andrés es_ES
dc.contributor.author Llinares Llopis, Raúl es_ES
dc.contributor.author Priego Quesada, Jose Ignacio es_ES
dc.contributor.author Llana-Belloch, Salvador es_ES
dc.contributor.author Pérez Soriano, Pedro es_ES
dc.date.accessioned 2018-06-08T04:24:31Z
dc.date.available 2018-06-08T04:24:31Z
dc.date.issued 2017 es_ES
dc.identifier.issn 1932-6203 es_ES
dc.identifier.uri http://hdl.handle.net/10251/103612
dc.description.abstract [EN] Each time the foot contacts the ground during running there is a rapid deceleration that results in a shock wave that is transmitted from the foot to the head. The fatigue of the musculoskeletal system during running may decrease the ability of the body to absorb those shock waves and increase the risk of injury. Insoles are commonly prescribed to prevent injuries, and both custom-made and prefabricated insoles have been observed to reduce shock accelerations during running. However, no study to date has included a direct comparison of their behaviour measured over the same group of athletes, and therefore great controversy still exists regarding their effectiveness in reducing impact loading during running. The aim of the study was to analyse the acute differences in stride and shock parameters while running on a treadmill with custom-made and prefabricated insoles. Stride parameters (stride length, stride rate) and shock acceleration parameters (head and tibial peak acceleration, shock magnitude, acceleration rate, and shock attenuation) were measured using two triaxial accelerometers in 38 runners at 3.33 m/s before and after a 15-min intense run while using the sock liner of the shoe (control condition), prefabricated insoles and custom-made insoles. No differences in shock accelerations were found between the custom-made and the control insoles. The prefabricated insoles increased the head acceleration rate (post-fatigue, p = 0.029) compared to the control condition. The custom-made reduced tibial (pre-fatigue, p = 0.041) and head acceleration rates (pre-fatigue and post-fatigue, p = 0.01 and p = 0.046) compared to the prefabricated insoles. Neither the stride nor the acceleration parameters were modified as a result of the intense run. In the present study, the acute use of insoles (custom-made, prefabricated) did not reduce shock accelerations compared to the control insoles. Therefore, their effectiveness at protecting against injuries associated with elevated accelerations is not supported and remains unclear. es_ES
dc.description.sponsorship This work was supported by the Spanish Government (Ministerio de Educacion, Cultura y Deporte, Grant FPU; and Ministerio de Economia y Competitividad, Subdireccion General de Proyectos de Investigacion, Convocatoria Proyectos I+D Excelencia, Subprograma de Generacion de Conocimiento, 2013, Grant DEP2013-48420-P). en_EN
dc.language Inglés es_ES
dc.publisher Public Library of Science es_ES
dc.relation.ispartof PLoS ONE es_ES
dc.rights Reconocimiento (by) es_ES
dc.subject Tibial Stress-Fracture es_ES
dc.subject Groung Reaction Force es_ES
dc.subject Shock Attenuation es_ES
dc.subject.classification TEORIA DE LA SEÑAL Y COMUNICACIONES es_ES
dc.title Influence of custom-made and prefabricated insoles before and after an intense run es_ES
dc.type Artículo es_ES
dc.identifier.doi 10.1371/journal.pone.0173179 es_ES
dc.relation.projectID info:eu-repo/grantAgreement/MINECO//DEP2013-48420-P/ES/NALISIS DE LA PLANTILLA DEPORTIVA: PREFABRICADAS VS PERSONALIZAS SOBRE PARAMETROS BIOMECANICOS EN FATIGA DURANTE LA CARRERA/ es_ES
dc.rights.accessRights Abierto es_ES
dc.contributor.affiliation Universitat Politècnica de València. Departamento de Comunicaciones - Departament de Comunicacions es_ES
dc.contributor.affiliation Universitat Politècnica de València. Instituto Universitario Mixto de Biomecánica de Valencia - Institut Universitari Mixt de Biomecànica de València es_ES
dc.description.bibliographicCitation Lucas-Cuevas, Á.; Camacho García, A.; Llinares Llopis, R.; Priego Quesada, JI.; Llana-Belloch, S.; Pérez Soriano, P. (2017). Influence of custom-made and prefabricated insoles before and after an intense run. PLoS ONE. 12(2). https://doi.org/10.1371/journal.pone.0173179 es_ES
dc.description.accrualMethod S es_ES
dc.relation.publisherversion http://doi.org/10.1371/journal.pone.0173179 es_ES
dc.type.version info:eu-repo/semantics/publishedVersion es_ES
dc.description.volume 12 es_ES
dc.description.issue 2 es_ES
dc.identifier.pmid 28245273 en_EN
dc.identifier.pmcid PMC5330490 en_EN
dc.relation.pasarela S\329774 es_ES
dc.contributor.funder Ministerio de Economía y Competitividad es_ES
dc.contributor.funder Ministerio de Educación, Cultura y Deporte


Este ítem aparece en la(s) siguiente(s) colección(ones)

Mostrar el registro sencillo del ítem