Analyzing the role of pulse density and voxelization parameters on full-waveform LiDAR-derived metrics

Abstract

[EN] LiDAR full-waveform (LFW) pulse density is not homogeneous along study areas due to overlap between contiguous flight stripes and, to a lesser extent, variations in height, velocity and altitude of the platform. As a result, LFW-derived metrics extracted at the same spot but at different pulse densities differ, which is called ¿side-lap effect¿. Moreover, this effect is reflected in forest stand estimates, since they are predicted from LFW-derived metrics. This study was undertaken to analyze LFW-derived metric variations according to pulse density, voxel size and value assignation method in order to reduce the side-lap effect. Thirty LiDAR samples with a minimum density of 16 pulses.m¿2 were selected from the testing area and randomly reduced to 2 pulses.m¿2 with an interval of 1 pulse.m¿2, then metrics were extracted and compared for each sample and pulse density at different voxel sizes and assignation values. Results show that LFW-derived metric variations as a function of pulse density follow a negative exponential model similar to the exponential semivariogram curve, increasing sharply until they reach a certain pulse density, where they become stable. This value represents the minimum pulse density (MPD) in the study area to optimally minimize the side-lap effect. This effect can also be reduced with pulse densities lower than the MPD modifying LFW parameters (i.e. voxel size and assignation value). Results show that LFW-derived metrics are not equally influenced by pulse density, such as number of peaks (NP) and ROUGHness of the outermost canopy (ROUGH) that may be discarded for further analyses at large voxel sizes, given that they are highly influenced by pulse density. In addition, side-lap effect can be reduced by either increasing pulse density or voxel size, or modifying the assignation value. In practice, this leads to a proper estimate of forest stand variables using LFW data.