[ES] Este proyecto consiste en evaluar y caracterizar las propiedades mecánicas de la
aleación de Titanio SP-700 para estudiar su conformabilidad y bajo qué condiciones se
puede trabajar para obtener un mejor comportamiento. ...[+]
[ES] Este proyecto consiste en evaluar y caracterizar las propiedades mecánicas de la
aleación de Titanio SP-700 para estudiar su conformabilidad y bajo qué condiciones se
puede trabajar para obtener un mejor comportamiento. Inicialmente, y mediante el uso
del simulador SFBT (Sistema de flexión bajo tensión) se realiza el estudio de los
coeficientes de fricción sometiendo a las probetas de titanio a una carga axial bajo
diferentes ángulos de inclinación de la máquina, velocidades de cilindros, diámetro de
pin donde se somete a rozamiento y tipo de lubricante. Posteriormente se mide la
rugosidad en la zona de deformación plástica para observar la relación entre el ángulo
de inclinación y el contacto con el pin. Finalmente se caracteriza este material realizando
ensayos de tensión y dureza para complementar la información y proceder a evaluar los
resultados y sacar conclusiones. Este análisis será usado para poder evaluar las
diferentes aplicaciones a las que puede ser sometido el Titanio SP-700.
[-]
[EN] This project consists of evaluating and characterizing the mechanical properties
of the SP-700 Titanium alloy to study its formability and under what conditions it can be
worked to obtain better behavior. Initially, ...[+]
[EN] This project consists of evaluating and characterizing the mechanical properties
of the SP-700 Titanium alloy to study its formability and under what conditions it can be
worked to obtain better behavior. Initially, and through the use of the SFBT simulator
(System of bending under tension), the study of the friction coefficients is carried out by
subjecting the titanium specimens to an axial load under different angles of inclination
of the machine, cylinder speeds, diameter of pin where it is subjected to friction and type
of lubricant. Subsequently, the roughness in the plastic deformation zone is measured to
observe the relationship between the angle of inclination and the contact with the pin.
Finally, this material is characterized by carrying out stress and hardness tests to
complement the information and proceed to evaluate the results and draw conclusions.
This analysis will be used to be able to evaluate the different applications to which
Titanium SP-700 can be subjected.
[-]
|