- -

A Test Method to Characterize Flexural Creep Behaviour of Pre-cracked FRC Specimens

RiuNet: Repositorio Institucional de la Universidad Politécnica de Valencia

Compartir/Enviar a

Citas

Estadísticas

  • Estadisticas de Uso

A Test Method to Characterize Flexural Creep Behaviour of Pre-cracked FRC Specimens

Mostrar el registro sencillo del ítem

Ficheros en el ítem

[Cerrado]
Nombre: Artículo EXP ...
Tamaño: 1.768Mb
Formato: PDF
Descripción: Versión editor
Solicitar una copia al autor
dc.contributor.author Arango Campo, Samuel Eduardo es_ES
dc.contributor.author Serna Ros, Pedro es_ES
dc.contributor.author Martí Vargas, José Rocío es_ES
dc.contributor.author García Taengua, Emilio José es_ES
dc.date.accessioned 2013-06-17T11:59:53Z
dc.date.available 2013-06-17T11:59:53Z
dc.date.issued 2011
dc.identifier.issn 0014-4851
dc.identifier.uri http://hdl.handle.net/10251/29746
dc.description.abstract [EN] This paper presents a proposal of test setup and methodology for testing the flexural creep behaviour of pre-cracked Fibre Reinforced Concrete (FRC) specimens, aimed at providing a basis for standardization. The design criteria used to define the equipment and methodology are presented. A test results sheet and a curve are established to present the results of creep tests, and some experimental results are shown so that the test can be validated. The equipment and methodology proposed make it possible to research the influence of factors such as concrete type, fibres type and content, applied load, and crack opening value. © 2011 Society for Experimental Mechanics. es_ES
dc.description.sponsorship The present study was supported by the Spanish Universitat Politecnica de Valencia (UPV), Valencia, Spain; by the project BIA 2009-12722 of the Spanish Ministry; and by the project "HABITAT 2030" [PS-380000-2008-11] funded by both the Spanish Ministry of Science and Innovation and the European Regional Development Found. The authors would like to express their gratitude for this support. en_EN
dc.language Inglés es_ES
dc.publisher Society for Experimental Mechanics es_ES
dc.relation.ispartof Experimental Mechanics es_ES
dc.rights Reserva de todos los derechos es_ES
dc.subject Bending es_ES
dc.subject Cracked state es_ES
dc.subject Creep es_ES
dc.subject Fibre reinforced concrete es_ES
dc.subject Test method es_ES
dc.subject Applied loads es_ES
dc.subject Concrete types es_ES
dc.subject Crack opening es_ES
dc.subject Creep behaviour es_ES
dc.subject Creep tests es_ES
dc.subject Design criterion es_ES
dc.subject Test setups es_ES
dc.subject Bending (forming) es_ES
dc.subject Reinforced concrete es_ES
dc.subject Creep testing es_ES
dc.subject.classification INGENIERIA DE LA CONSTRUCCION es_ES
dc.title A Test Method to Characterize Flexural Creep Behaviour of Pre-cracked FRC Specimens es_ES
dc.type Artículo es_ES
dc.identifier.doi 10.1007/s11340-011-9556-2
dc.relation.projectID info:eu-repo/grantAgreement/MICINN//BIA2009-12722/ES/El hormigón de fibras de acero como superación del hormigón tradicional y sus perspectivas de futuro/ es_ES
dc.relation.projectID info:eu-repo/grantAgreement/MICINN//PSE-380000-2008-002/ES/Habitat 2030: Materiales y componentes es_ES
dc.rights.accessRights Cerrado es_ES
dc.contributor.affiliation Universitat Politècnica de València. Departamento de Ingeniería de la Construcción y de Proyectos de Ingeniería Civil - Departament d'Enginyeria de la Construcció i de Projectes d'Enginyeria Civil es_ES
dc.contributor.affiliation Universitat Politècnica de València. Instituto de Ciencia y Tecnología del Hormigón - Institut de Ciència i Tecnologia del Formigó es_ES
dc.description.bibliographicCitation Arango Campo, SE.; Serna Ros, P.; Martí Vargas, JR.; García Taengua, EJ. (2011). A Test Method to Characterize Flexural Creep Behaviour of Pre-cracked FRC Specimens. Experimental Mechanics. 52(8):1067-1078. https://doi.org/10.1007/s11340-011-9556-2 es_ES
dc.description.accrualMethod S es_ES
dc.relation.publisherversion http://link.springer.com/content/pdf/10.1007%2Fs11340-011-9556-2.pdf es_ES
dc.description.upvformatpinicio 1067 es_ES
dc.description.upvformatpfin 1078 es_ES
dc.type.version info:eu-repo/semantics/publishedVersion es_ES
dc.description.volume 52 es_ES
dc.description.issue 8 es_ES
dc.relation.senia 223937
dc.contributor.funder Ministerio de Ciencia e Innovación es_ES
dc.contributor.funder Universitat Politècnica de València es_ES
dc.contributor.funder European Regional Development Fund es_ES
dc.description.references fib (2010) MODEL CODE 2010 (First complete draft) es_ES
dc.description.references Ministerio de Fomento (2008) EHE-08 Instrucción de Hormigón Estructural. Real Decreto 1247/2008 es_ES
dc.description.references American Concrete Institute (2008) ACI 318–08. ACI Committee 318: Building Code Requirements for reinforced Concrete. Farmington Hills, MI es_ES
dc.description.references European Standards (2007) EN 14651:2007. Test method for metallic fibre concrete - Measuring the flexural tensile strength (limit of proportionality (LOP), residual) es_ES
dc.description.references Bernard ES (2004) Creep of cracked fibre reinforced shotcrete panels. In: Shotcrete: More Engineering Developments. Taylor & Francis Group, London, pp 47–57 es_ES
dc.description.references Mangat PS, Motamedi M (1986) Compression creep behaviour of steel fibre reinforced cement composites. Mater Struct 19(113):361–369 es_ES
dc.description.references Chern JC, Young CH (1989) Compressive creep and shrinkage of steel fibre reinforced concrete. Int J Cem Lightweight Concr 11(4):205–214 es_ES
dc.description.references Barragán BE, Zerbino RL (2008) Creep behaviour of cracked steel fibre reinforced concrete beams. In: Proceedings of the 7th Int. RILEM Symp. on Fibre Reinforced Concrete: Design and Applications (BEFIB 2008). Chennai, pp 577–586 es_ES
dc.description.references Erzar B, Forquin P (2010) An experimental method to determine the tensile strength of concrete at high rates of strain. Exp Mech 50:941–955. doi: 10.1007/s11340-009-9284-z es_ES
dc.description.references Chen TC, Yin WQ, Ifju PG (2010) Shrinkage measurement in concrete materials using cure reference method. Exp Mech 50:999–1012. doi: 10.1007/s11340-009-9300-3 es_ES
dc.description.references Granju JL, Rossi P, Chanvillard G, et al (2000) Delayed behaviour of cracked SFRC beams. In: Proceedings of the 5th Int. RILEM Symp. on Fibre Reinforced Concrete (BEFIB 2000). Lyon, pp 511–520 es_ES
dc.description.references Chanvillard G, Roque O (1999) Behaviour of fibre reinforced concrete cracked section under sustained load. In: Proceedings of the 3rd Int. Workshop on High Performance Fibre Reinforced Cement Composites (HPFRCC3). RILEM publications, Mainz, pp 239–250 es_ES
dc.description.references Mackay J, Trottier JF (2004) Post-crack behaviour of steel and synthetic FRC under flexural loading. In: Shotcrete: More Engineering Developments. Taylor & Francis Group, London, pp 183–192 es_ES
dc.description.references Cochrane JT (2003) Flexural creep behaviour of fibre reinforced concrete under high temperatures. Master of applied science thesis, Dalhousie University. Canada es_ES
dc.description.references Mackay J (2002) Behaviour of steel and synthetic fibre reinforced concrete under flexural creep loading. Master of applied science thesis, Dalhousie University. Canada es_ES
dc.description.references Bast T, Eder A, Kusterle W (2007) Kriechversuche an kunststoffmakrofaserbetonen-Untersuchungen zum langzeitverhalten von faserbetonen unter biegezugbeanspruchung. Ein zwischenbericht. Faserbeton beiträge zum 11. Vilser Baustofftag, pp 32–35 es_ES
dc.description.references Swamy RN, Theodorakopoulos DD (1979) Flexural creep of fibre reinforced cement composites. Int J Cem Lightweight Concr 1(1):37–47 es_ES
dc.description.references Kurtz S, Balaguru P (2000) Postcrack creep of polymeric fibre-reinforced concrete in flexure. Cem Concr Res 30:183–90 es_ES
dc.description.references Buratti N, Mazzotti C, Savoia (2010) Long-term behaviour of fiber reinforced SCC beams. In: Proceedings of the 6th Int. RILEM Symposium on Self Compacting Concrete. Montreal, pp 439–450 es_ES
dc.description.references Torrijos MC, Barragán BE, Zerbino RL (2010) Placing conditions, mesostructural characteristics and post-cracking response of fibre reinforced self-compacting concretes. Constr Build Mater 24:1078–1085 es_ES
dc.description.references Arango SE (2010) Fluencia a flexión del hormigón reforzado con fibras de acero (SFRC) en estado fisurado. PhD Thesis, Universitat Politècnica de València. Spain es_ES
dc.description.references AENOR (2004) UNE 83.502:2004. Hormigones con fibras. Fabricación en laboratorio. Asociación Española de Normalización y Certificación, Madrid es_ES
dc.description.references AENOR (2004) UNE 83.503:2004. Hormigones con fibras. Medida de la docilidad por medio del cono invertido. Asociación Española de Normalización y Certificación, Madrid es_ES
dc.description.references AENOR (2004) UNE 83.504:2004. Hormigones con fibras. Fabricación y conservación de probetas para los ensayos de laboratorio. Asociación Española de Normalización y Certificación, Madrid es_ES
dc.description.references AENOR (2009) UNE-EN 12350–2:2009. Ensayos de hormigón fresco. Parte 2: Ensayo de asentamiento. Asociación Española de Normalización y Certificación, Madrid es_ES


Este ítem aparece en la(s) siguiente(s) colección(ones)

Mostrar el registro sencillo del ítem