An experimental study of process variables in turning operations of Ti 6Al 4V and Cr Co spherical prostheses

Abstract

[EN] Ti 6Al 4V and Cr Co alloys are extensively used in manufacturing prostheses due to their biocompatibility, high strength-to-weight ratio and high resistance to corrosion and wear. However, machining operations involving Ti 6Al 4V and Cr Co alloys face a series of difficulties related to their low machinability which complicate the process of controlling the quality levels required in these parts. The main objective of this paper is to study the influence of cutting parameters, machine tool control accuracy and metrology procedures on surface roughness parameters and form errors in contouring operations of Ti 6Al 4V and Cr Co workpieces. The machining performance of the two biocompatible materials is compared, focusing the study on part quality at low feed per revolution and the stochastic nature of plastic deformations at this regime. The results showed a better surface roughness control for Ti 6Al 4V, whereas for Cr Co alloys, the performance presents high variability. In the case of form errors (sphericity), contouring errors and metrology procedures are important factors to be considered for quality assurance. In addition, the study analyses the correlation of the machining performance with different sensor signals acquired from a low cost non-intrusive multi-sensor, showing a high correlation of signals from acoustic emission sensors and accelerometers in the machining of spherical features on Ti 6Al 4V parts. The findings of this research work can be taken into account when designing prostheses components and planning their manufacturing processes.