A novel methodology to assist manufacturers in the heat exchanger sizing for variable-speed heat pumps based on part load conditions and economic assessment

Abstract

[EN] Matts Bäckstöm assessed the selection criteria of heat exchangers for single-speed heat pumps in 1940, and his methodology and conclusions have been kept practically unchanged for almost a century. However, heat pump systems have evolved, especially with the introduction of variable-speed heat pumps. These new systems introduced a new degree of freedom to the heat pump design ¿ the compressor speed ¿ which is not considered by traditional design criteria. This study proposes novel design criteria to optimize the heat exchanger size when the heat pump unit can work under part-load conditions. The proposed method models how heat exchangers and variable-speed compressors perform under different loads and sizes. It considers part-load requirements based on climatic data (which are typically available in the standards) and considers economic factors such as initial investment and operation costs (which are dependent on the components's size). Given the mentioned information, a multivariable optimization algorithm is implemented to find the optimum heat exchanger size that minimizes the total cost. To validate the proposed approach's effectiveness, it was exemplified by determining the optimum size of a coil and a plate heat exchanger for a domestic variable-speed heat pump. The results demonstrate that using traditional criteria could lead to over-dimensioning heat exchangers in variable-speed heat pumps which could incur in an increase of costs of 5% for the studied case.