Operational effectiveness of passing zones depending on their length and traffic volume

Abstract

Most studies on two-lane highway operations have focused on the percentage of following vehicles or the adjustment of the Highway Capacity Manual (HCM) procedure to local data. The HCM proposes the length of no-passing zones as a model parameter; however, the distribution and characteristics of passing zones are not addressed. In fact, only a few studies on the expected number of passes in a passing zone have been carried out. This research presents an analysis of the effectiveness of passing zones in terms of their length and traffic volume. Data were collected from four passing zones on a rural highway in Spain. The two-way traffic volumes ranged from 100 to 900 vehicles per hour (vph), and the passing zone lengths ranged from 265 to 1,270 m. More than 1,600 passing maneuvers were recorded. The operational effectiveness of the passing zones was obtained from the passing frequency and the passing rate. The results indicated that the longer the passing zone, the higher the passing frequency; however, the results stabilized with lengths above 1,100 m. Balanced flows with two-way traffic volumes between 600 and 700 vph optimized the number of passes. Nevertheless, the increase in the passing frequency with the traffic volume was lower than with the increase in following vehicles. The results were validated with data from another 12 passing zones. Finally, HCM adjustments based on the percentage of no-passing zones did not reliably represent the effectiveness of passing zones. Therefore, the effectiveness of every passing zone should be considered, and adjustment factors should be modified to maximize the passing opportunities for traffic volumes between 600 and 700 vph.