- -

Novel Wireless Sensor System for Dynamic Characterization of Borehole Heat Exchangers

RiuNet: Repositorio Institucional de la Universidad Politécnica de Valencia

Compartir/Enviar a

Citas

Estadísticas

  • Estadisticas de Uso

Novel Wireless Sensor System for Dynamic Characterization of Borehole Heat Exchangers

Mostrar el registro completo del ítem

Martos Torres, J.; Montero Reguera, ÁE.; Torres Pais, J.; Soret Medel, J.; Martinez, G.; García Olcina, R. (2011). Novel Wireless Sensor System for Dynamic Characterization of Borehole Heat Exchangers. Sensors. 11(7):7082-7094. https://doi.org/10.3390/s110707082

Por favor, use este identificador para citar o enlazar este ítem: http://hdl.handle.net/10251/59976

Ficheros en el ítem

Metadatos del ítem

Título: Novel Wireless Sensor System for Dynamic Characterization of Borehole Heat Exchangers
Autor: Martos Torres, Julio Montero Reguera, Álvaro Enrique Torres Pais, Jose Soret Medel, Jesús Martinez, Guillermo García Olcina, Raimundo
Entidad UPV: Universitat Politècnica de València. Departamento de Termodinámica Aplicada - Departament de Termodinàmica Aplicada
Fecha difusión:
Resumen:
The design and field test of a novel sensor system based in autonomous wireless sensors to measure the temperature of the heat transfer fluid along a borehole heat exchanger (BHE) is presented. The system, by means of two ...[+]
Palabras clave: Heat pumps , Geothermal energy , Thermal analysis , Wireless sensors
Derechos de uso: Reconocimiento (by)
Fuente:
Sensors. (issn: 1424-8220 )
DOI: 10.3390/s110707082
Editorial:
MDPI
Versión del editor: http://dx.doi.org/10.3390/s110707082
Código del Proyecto:
info:eu-repo/grantAgreement/MICINN//ENE2008-00599/ES/MODELADO, SIMULACION Y VALIDACION EXPERIMENTAL DE LA TRANSFERENCIA DE CALOR EN EL ENTORNO DE LA EDIFICACION/
Agradecimientos:
This work was supported by the Spanish Government under the projects "Modeling and simulation of complex energetic systems" ("Modelado y simulacion de sistemas energeticos complejos", Ramon y Cajal research program 2005) ...[+]
Tipo: Artículo

References

Urchueguía, J. F., Zacarés, M., Corberán, J. M., Montero, Á., Martos, J., & Witte, H. (2008). Comparison between the energy performance of a ground coupled water to water heat pump system and an air to water heat pump system for heating and cooling in typical conditions of the European Mediterranean coast. Energy Conversion and Management, 49(10), 2917-2923. doi:10.1016/j.enconman.2008.03.001

http://www.marshallhvac.com/residential-geothermal.html

Genchi, Y., Kikegawa, Y., & Inaba, A. (2002). CO2 payback–time assessment of a regional-scale heating and cooling system using a ground source heat–pump in a high energy–consumption area in Tokyo. Applied Energy, 71(3), 147-160. doi:10.1016/s0306-2619(02)00010-7 [+]
Urchueguía, J. F., Zacarés, M., Corberán, J. M., Montero, Á., Martos, J., & Witte, H. (2008). Comparison between the energy performance of a ground coupled water to water heat pump system and an air to water heat pump system for heating and cooling in typical conditions of the European Mediterranean coast. Energy Conversion and Management, 49(10), 2917-2923. doi:10.1016/j.enconman.2008.03.001

http://www.marshallhvac.com/residential-geothermal.html

Genchi, Y., Kikegawa, Y., & Inaba, A. (2002). CO2 payback–time assessment of a regional-scale heating and cooling system using a ground source heat–pump in a high energy–consumption area in Tokyo. Applied Energy, 71(3), 147-160. doi:10.1016/s0306-2619(02)00010-7

Sanner, B., Karytsas, C., Mendrinos, D., & Rybach, L. (2003). Current status of ground source heat pumps and underground thermal energy storage in Europe. Geothermics, 32(4-6), 579-588. doi:10.1016/s0375-6505(03)00060-9

Pardo, N., Montero, Á., Sala, A., Martos, J., & Urchueguía, J. F. (2011). Efficiency improvement of a ground coupled heat pump system from energy management. Applied Thermal Engineering, 31(2-3), 391-398. doi:10.1016/j.applthermaleng.2010.09.016

Pardo, N., Montero, Á., Martos, J., & Urchueguía, J. F. (2010). Optimization of hybrid – ground coupled and air source – heat pump systems in combination with thermal storage. Applied Thermal Engineering, 30(8-9), 1073-1077. doi:10.1016/j.applthermaleng.2010.01.015

http://projects.gtk.fi/Annex21/trt.htm/

Beier, R. A. (2011). Vertical temperature profile in ground heat exchanger during in-situ test. Renewable Energy, 36(5), 1578-1587. doi:10.1016/j.renene.2010.10.025

Marcotte, D., & Pasquier, P. (2008). On the estimation of thermal resistance in borehole thermal conductivity test. Renewable Energy, 33(11), 2407-2415. doi:10.1016/j.renene.2008.01.021

Raymond, J., Therrien, R., & Gosselin, L. (2011). Borehole temperature evolution during thermal response tests. Geothermics, 40(1), 69-78. doi:10.1016/j.geothermics.2010.12.002

Beier, R. A., Smith, M. D., & Spitler, J. D. (2011). Reference data sets for vertical borehole ground heat exchanger models and thermal response test analysis. Geothermics, 40(1), 79-85. doi:10.1016/j.geothermics.2010.12.007

Bandos, T. V., Montero, Á., Fernández, E., Santander, J. L. G., Isidro, J. M., Pérez, J., … Urchueguía, J. F. (2009). Finite line-source model for borehole heat exchangers: effect of vertical temperature variations. Geothermics, 38(2), 263-270. doi:10.1016/j.geothermics.2009.01.003

Raymond, J., Therrien, R., Gosselin, L., & Lefebvre, R. (2011). A Review of Thermal Response Test Analysis Using Pumping Test Concepts. Ground Water, 49(6), 932-945. doi:10.1111/j.1745-6584.2010.00791.x

Bandos, T. V., Montero, Á., Fernández de Córdoba, P., & Urchueguía, J. F. (2011). Improving parameter estimates obtained from thermal response tests: Effect of ambient air temperature variations. Geothermics, 40(2), 136-143. doi:10.1016/j.geothermics.2011.02.003

Fujii, H., Okubo, H., Nishi, K., Itoi, R., Ohyama, K., & Shibata, K. (2009). An improved thermal response test for U-tube ground heat exchanger based on optical fiber thermometers. Geothermics, 38(4), 399-406. doi:10.1016/j.geothermics.2009.06.002

[-]

recommendations

 

Este ítem aparece en la(s) siguiente(s) colección(ones)

Mostrar el registro completo del ítem