- -

Monitorización del salado y post-salado de lomo mediante ultrasonidos

RiuNet: Repositorio Institucional de la Universidad Politécnica de Valencia

Compartir/Enviar a

Citas

Estadísticas

  • Estadisticas de Uso

Monitorización del salado y post-salado de lomo mediante ultrasonidos

Mostrar el registro sencillo del ítem

Ficheros en el ítem

dc.contributor.advisor García Pérez, José Vicente es_ES
dc.contributor.advisor Benedito Fort, José Javier es_ES
dc.contributor.author Miota Soriano, Paula es_ES
dc.date.accessioned 2017-01-10T11:46:17Z
dc.date.available 2017-01-10T11:46:17Z
dc.date.created 2016-12-21
dc.date.issued 2017-01-10 es_ES
dc.identifier.uri http://hdl.handle.net/10251/76555
dc.description.abstract [ES] Dada la gran variabilidad composicional y estructural de la carne, así como de las condiciones de procesado, el establecer tiempos fijos de salado y post-salado puede dar lugar a una elevada heterogeneidad en la calidad final de los productos cárnicos crudo-curados. Las técnicas que se emplean actualmente para controlar el salado y post-salado de estos productos implican el uso de métodos destructivos, que analizan el contenido en sal y agua de la muestra al finalizar el proceso, lo que conlleva que se generalicen los resultados para una misma partida de carne, en base a un número reducido de muestras analizadas. El objetivo general de este trabajo fue evaluar la viabilidad de los ultrasonidos de señal como técnica no destructiva, para caracterizar el proceso de salado y post-salado de carne de cerdo (Longissimus dorsi, LD) con lo que poder establecer relaciones entre los parámetros ultrasónicos obtenidos de forma no destructiva de la muestra de lomo (LD) y los cambios en el contenido y distribución de sal dentro de los lomos durante el salado y post-salado. Se midió de forma automática el tiempo de vuelo (Tv) cada 5 minutos durante el salado y post-salado. Se ensayaron 5 tiempos de post-salado (14, 28, 43, 56 y 72 h). Al finalizar el proceso de post-salado, se determinó el gradiente de sal, de humedad y de dureza entre la zona externa e interna de los lomos. Por último se establecieron las relaciones entre las variables composicionales y texturales y el incremento del tiempo de vuelo. El gradiente de humedad dentro de la pieza de lomo se redujo durante el post-salado llegando a una situación de equilibrio a las 43 h. Por otro lado, el gradiente de sal también disminuyó, mostrando una estabilización a las 28 h. En el caso del gradiente de dureza, también se observó una tendencia descendente con el tiempo de post-salado, aunque la variabilidad experimental no permitió encontrar diferencias significativas (p>0.05) entre los diferentes tiempos de post-salado. La variación del tiempo de vuelo dividida por el tiempo de vuelo inicial (ΔTv /Tv0) disminuyó con el tiempo de post-salado, estabilizándose a partir de las 43 h de post-salado, lo que, coincide con el momento en el que dejan de producirse cambios significativos en el gradiente de sal y de humedad. Los resultados obtenidos mostraron que los ultrasonidos de señal permiten monitorizar adecuadamente la etapa de post-salado de Longissimus dorsi (LD), estimando el momento en el que se estabilizan los cambios composicionales y texturales en la carne. es_ES
dc.description.abstract [EN] Due to the great compositional and structural variability of the meat as well as the processing conditions, to establish a fixed time of salting and post-salting lead to a high heterogeneity in the final quality of the meat dry-cured products. The techniques currently used to control the salting and post-salting of these products involve the use of destructive methods, which analyze the salt and water content of the sample at the end of the process, which means that the results are generalized for the same lot of meat, based on a small number of samples analyzed. The main objective of the present work was to determine the viability of using low intensity ultrasound as a non‐destructive technique to monitor the salting and post-salting process of pork (Longissimus dorsi, LD) with which to establish relations between the ultrasonic parameters obtained in a non-destructive way from the loin sample (LD) and changes in the content and distribution of salt inside the loins during salting and post-salting. The time of flight was measured automatically every 5 minutes during the salting and postsalting process. 5 post-salting times (14, 28, 43, 56 and 72 h) were tested. When the postsalting process finished, the gradient of salt, moisture and hardness were determined between the external and internal zones of the loins. Finally, the relationships between the compositional and textural variables and the variation of the time of flight were established. The moisture gradient inside the loin was reduced during post-salting, reaching equilibrium at 43 h. On the other hand, the salt gradient also decreased, showing stabilization at 28 h. In the case of the hardness gradient, a downward trend was also observed with the post-salting time, however, the experimental variability did not allow to find significant differences (p> 0.05) between the different post-salting times. The variation of the time of flight divided by the initial time of flight (ΔTv /Tv0) decreased with the post-salting time, becoming stable after the 43 h of post-salting, which, coincides with the moment in which significant changes in the gradient of salt and of dampness stop producing. The results obtained showed that low intensity ultrasounds allow to suitably monitor the period of post-salting of Longissimus Dorsi (LD), estimating the moment in which compositional and textural changes in the meat stabilize. es_ES
dc.format.extent 61 es_ES
dc.language Español es_ES
dc.publisher Universitat Politècnica de València es_ES
dc.rights Reconocimiento - No comercial - Compartir igual (by-nc-sa) es_ES
dc.subject Carne es_ES
dc.subject Salado es_ES
dc.subject Lomo es_ES
dc.subject Post-salado es_ES
dc.subject Ultrasonidos de señal es_ES
dc.subject Análisis no destructivo es_ES
dc.subject Meat es_ES
dc.subject Salting process es_ES
dc.subject Post-salting process es_ES
dc.subject Low intensity ultrasound es_ES
dc.subject Non-destructive analysis es_ES
dc.subject.classification TECNOLOGIA DE ALIMENTOS es_ES
dc.subject.other Grado en Ingeniería Agroalimentaria y del Medio Rural-Grau en Enginyeria Agroalimentària i del Medi Rural es_ES
dc.title Monitorización del salado y post-salado de lomo mediante ultrasonidos es_ES
dc.type Proyecto/Trabajo fin de carrera/grado es_ES
dc.rights.accessRights Abierto es_ES
dc.contributor.affiliation Universitat Politècnica de València. Departamento de Tecnología de Alimentos - Departament de Tecnologia d'Aliments es_ES
dc.contributor.affiliation Universitat Politècnica de València. Escuela Técnica Superior de Ingeniería Agronómica y del Medio Natural - Escola Tècnica Superior d'Enginyeria Agronòmica i del Medi Natural es_ES
dc.description.bibliographicCitation Miota Soriano, P. (2016). Monitorización del salado y post-salado de lomo mediante ultrasonidos. http://hdl.handle.net/10251/76555. es_ES
dc.description.accrualMethod TFGM es_ES
dc.relation.pasarela TFGM\48562 es_ES


Este ítem aparece en la(s) siguiente(s) colección(ones)

Mostrar el registro sencillo del ítem