[EN] This paper compares two non-parametric programming techniques for the measurement of total factor productivity using panel data: Malmquist indices and an intertemporal-DEA model that allows the calculation of technology ...

[ES] El presente Trabajo de Fin de Grado surge de la necesidad de adaptar las empresas a una situación cada vez más competitiva. En particular, se centra en Paconfi S.L., empresa del sector calzado situada en la provincia ...

[EN] In this paper an analysis of productivity will be carried out from the resolution of the problem of trajectory planning of industrial robots. The analysis entails economic considerations, thus overcoming some limitations ...

[EN] The analysis of the competitiveness of chesee corn doughs production units in the Town of Arcabuco-Boyacá (Colombia) requires the theoretical foundation and knowledge of the factors that give rise to its importance ...

[EN] The aim of this current work is to show a methodology with its procedures and steps that must be conducted by any entrepreneur at the moment to start its own business or SME or when this is working. Moreover, it will ...

[EN] The dependence of the industrial maintenance engineering team remains vital, having a major impact on the operating results of the maintenance department, and therefore the company. Management of the knowledge of that ...

[EN] The Final Degree Project aims to meet the wind potential of economic performance in the province of Castellón (additional installation MW) with the current technology available. To this end, our study will consist ...

[EN] The Environmental Impact Study about the improvements and rehabilitation of the irrigation system Chacaloma-Huasipungos. It is a very relevant project to make decision and the characterization of the study zone. The ...

[EN] This study is intended to find the eolic potential of Alicante and characterize its territory in terms of viability for the wind farms installation. According to this purpose we resort to two analyzes: One site ...

[ES] El presente proyecto es el resultado de las prácticas realizadas en la empresa Fáperin S.L., en las que se ha realizado un estudio del proceso de cambio de molde en máquinas de inyección de plástico con el objetivo ...